Formed Wire Dead-end for ADSS Cable

Formed wire dead-end is a type of hardware used in the installation of ADSS (all-dielectric self-supporting) cables. These cables are commonly used in the telecommunications industry to transmit data and voice signals over long distances. The formed wire dead-end is an essential component of the ADSS cable system, providing support and anchorage for the cable.

The formed wire dead-end is made of high-strength galvanized steel wire that is formed into a loop at one end and a hook at the other. The loop end is used to attach the dead-end to the ADSS cable, while the hook end is used to anchor the cable to a support structure, such as a pole or tower. The dead-end is designed to withstand the tension and weight of the cable, as well as the forces caused by wind and ice.

Installation of the formed wire dead-end is relatively simple. The loop end is attached to the ADSS cable by threading the cable through the loop and then clamping it securely in place. The hook end is then attached to the support structure using a bolt or other fastener. The dead-end can be installed at any point along the cable but is typically placed at intervals of 300-500 meters to provide adequate support.

The formed wire dead-end is a reliable and cost-effective solution for ADSS cable installation. It is lightweight and easy to handle, making it ideal for use in remote or difficult-to-reach locations. It also requires minimal maintenance, as it is resistant to corrosion and other environmental factors.

In summary, the formed wire dead-end is an essential component of the ADSS cable system. It's high-strength construction and simple installation make it an ideal choice for telecommunications companies looking to install reliable and cost-effective cable networks.